12/15/2023 0 Comments Spectre performance carb hatYou'd need anĪdapter to be able to use that nut on this plenum.Ĭan you just buy anything that fits and have it work the same as the most expensive one? The answer to that is no. Spectre is 1/4" while this Holley carburetor uses a 5/16" thread. Note the "low profile" wing nut offered by Pre-Turbo installation of the Spectre 9849. These are just the physical characteristics, what about the actual results of these things? Not to mention several manufactures (like Spectre) offer low profile versions for those with short hood clearance. They come in different sizes and finishes as well as with, or without an internal divider. Interestingly enough, purchasing a carb hat isn't that simple. Hopefully the profit made on these is paying off all the R&D staff as they probably cost very little to manufacture. Overall it feels like a high quality part but at $99US it's not cheap for what it is. It's polished aluminium and quite hefty. The size is good but like any part mounting to the top of your engine, be sure you have enough clearance between it and the hood. It should fit nicely on the Holley 4776 600CFM DP with mechanical secondaries. It is 3.5" tall, 9" long and has a 4" intake and it fits on any carburetor with a 5-1/8" inlet. The purchased part is a Spectre 9849 single intake regular height hat. Take the carburetor hat (bonnet or plenum) for example. None of the parts used in Turbo Camaro are the best of the best, but they are likely the best bang for your buck. All products have to be well made, performance capable and affordable. Slowly but surly the list was reviewed and each item meticulously researched. Once it was decided to run a turbocharger, a list of components was made. Spectre hat with 4" intake and 5-1/8" outlet Spectre 9849 Polished Carburetor Hat - $99
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |